EnGenius ECB9500 Bedienungsanleitung PDF herunterladen (Seite 28)

Multi-Function Gigabit Wireless-N Client Bridge Version 2.0

 WPS: Place a check in this box to

enable this feature.

 WPS Current Status: Displays the current status of the WPS configuration.

 Self Pin Code: Displays the current PIN.

 SSID: Displays the current SSID.

 Authentication Mode: Displays the current authentication mode.

 Passphrase Key: Displays the current passphrase.

 WPS Via Push Button: Click on the Start to Process button if you would like to

enable WPS through the Push Button instead of the PIN. After pressing this button

you will be required to press the WPS on the client device within two minutes. Click

on the OK button in the dialog box.

 WPS via PIN: Specify a PIN, which unique number that can be used to add the

router to an existing network or to create a new network. Then click on the Start to

Process button.

 Click on the Apply button to save the changes.

3.2.4.2.7 Client List

 Click on the Client List link under the Wireless drop-down menu. This page displays

the list of Clients that are associated to the Access Point.

 The MAC address and signal strength for each client is displayed. Click on the

Refresh button to refresh the client list

3.2.4.2.8 VLAN

 Click on the VLAN link under the Wireless drop-down menu. A VLAN (Virtual LAN)

is a group of hosts with a common set of requirements that communicate as if they

were attached to the same wire, regardless of their physical location.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Keine Kommentare

EnGenius ECB9500 Bedienungsanleitung Seite 28